My biggest problems start when I want to incorporate test data with 200% shear strain.

C10 would be half the initial shear modulus D would be two over the bulk modulus Regards

Hello again, is there any parameter that I have to set to a specific value if I want a strain-rate independent hysteresis material model in ABAQUS? F...

Thanks. Already sent a question asking for specifics. Thanks again!

To add to the previous post, when Im modeling the confined compression test on ABAQUS with D1=2/K the resulting K Im getting is always smaller. Any id...

Yes. Bulk modulus (K) was measured via a confined bulk modulus test. The obtained value was close to values reported in the literature (~400ksi). The ...

Hello and thanks for the fast reply. I am testing neoprene material and I am pretty sure the experimental data is correct. The testing I am conductin...