Search
Close this search box.

MCalibration Command Line Arguments

Using MCalibration from the Command Line

MCalibration can be used from the command line on both Linux and Windows computers. Here’s a list of the available command line arguments:

  • -help
  • -runOnce runs the specified simulation, saves the results, and then quits
  • -optimize runs the specified optimization, saves the results, and then quits
  • -model [name] select the specified material model, e.g. PolyUMod_BB
  • -noGUI do not show the GUI
  • -validate_mcal run a set of validation tests to make sure MCalibration has been installed correctly
  • -saveEng save the experimental data as engineering stress and strain
  • filename name of one MCalibration input file
Facebook
Twitter
LinkedIn

More to explore

Extended Tube Model in Ansys Mechanical

The Extended Tube model is one of the most accurate hyperelastic material models available, but it can be difficult to use if you don’t understand how the material parameters influence the predicted stress-strain response. This article will demonstrate that by example.

Leave a Comment