Material Model for POM (KEPITAL TS-25H)

Introduction - Material Model for POM

Here is a calibrated material model for a polyoxymethylene (POM) KEPITAL TS-25H tested at room temperature. To use this material model you will need to first install the MCalibration software, and then export the model to your favorite FE software. The calibrated material model is the PolyUMod Three Network (TN) model.

Jorgen

More to explore

Create a TTS Master Curve

One Common Huge Mistake When Creating a TTS Master Curve

This article demonstrates one common mistake that people make when they generate a TTS Master Curve from DMA data.

Use Transverse Strain Data in a Material Model Calibration

When performing uniaxial tests, you should consider also recording the transverse strain. This article shows how use the transverse strain data.

Complete Guide to Using PolyUMod with COMSOL Multiphysics

Guide to using MCalibration and PolyUMod with COMSOL Multiphysics. A complete start-to-finish tutorial is presented.

Leave a Comment Cancel Reply

You must be logged in to post a comment.