Search
Close this search box.
Notifications
Clear all

VDISP-quasi-static analysis in ABAQUS Explicit

3 Posts
2 Users
0 Likes
845 Views
Posts: 26
Topic starter
(@sandra)
Eminent Member
Joined: 15 years ago

Hello all,

I use ABAQUS Explicit user subroutine VDISP to simulate pin loading in a tensile test (displacement mode) on a single edge notched plate.

When I run the simulation, I have noticed that the displacements (that are applied to the top surface) do not propagate to the adjacent elements.

I have used similar boundary conditions on the same plate using ABAQUS-Standard disp subroutine and I obtain expected results.

I am certain that VDISP is quite accurate. Is there something about the Dynamic explicit analysis that would cause this kind of error. Does this have to the speed of deformation, or time step.

thanks in advance for suggestions.

Brunda

Topic Tags
2 Replies
Posts: 3998
(@jorgen)
Member
Joined: 5 years ago

It sounds like you are deforming the material so fast that inertial effects become large and the material deformation inhomogeneous...

-Jorgen

Topic Tags
2 Replies
Posts: 26
Topic starter
(@sandra)
Eminent Member
Joined: 15 years ago

Thanks for the quick reply.

So a small time step should probably resolve the problem eh?

On a related note, how do we know about the inertial effects? I have seen that in .sta file, the % change is mass is of the order of e11. Is that really high?

Brunda

Reply
Share: