Dear all,
I am trying to build an anisotropic hyperelastic model (Fung-orthotropic) in Abaqus CAE.
Can i get the material constants from uniaxial tensile test ? if so ,how ?
Thanks & Regards,
Beeyan
Menu
Login Using Old Accounts
All old passwords were reset when this site was migrated to WordPress. You can change your password by clicking on the "Login" item in the "Support" menu, and then selecting "Lost your password".
Notifications
Clear all
Jun 11, 2019 11:04 am
1 Reply
Nov 05, 2019 2:29 am
For anisotropic material models you need experimental data obtained in multiple directions. The number of directions and loading modes that are needed depend on the amount and type of anisotropy of your material.
-Jorgen