Login Using Old Accounts All old passwords were reset when this site was migrated to WordPress. You can change your password by clicking on the "Login" item in the "Support" menu, and then selecting "Lost your password".

Notifications

Clear all

Recent Posts

Forums | Topics

	Topic Title	Forum
	shape factor effect By Kian 7 days ago \| Last Post: 3 days ago	Foams
	Yes, absolutely! As long as you provide the correc... 3 days ago By Jorge... Hi Jorgen, Considering that the material constan... 7 days ago By Kian
	Calibration of uniaxial tension and compression test By Alexandre 2 weeks ago \| Last Post: 4 days ago	MCalibration Support Questions
	@jbrektor Hi Dr Jorgen...I have noticed a similar ... 4 days ago By aravi... @jorgen thanks for the tip! Do you have some sug... 1 week ago By Alexa... Yes, that should work fine. Note, however, that th... 1 week ago By Jorge... @jbrektor thanks for your reply! I am able to fi... 1 week ago By Alexa... Hello Alexandre, As you noticed, for some reason A... 1 week ago By jbRek... Hi PolymerFEM community, I'm a beginner on this ... 2 weeks ago By Alexa...
	Nanoindentation Simulation - Prescribe Indentation Load Instead of Indentation Depth? By baotho 4 years ago \| Last Post: 6 days ago	Finite Element Modeling
	What material models have you found necessary for ... 6 days ago By zvexl... I have used that approach many times and it has wo... 4 years ago By Jorge... Im trying to simulate the nanoindentation of ceram... 4 years ago By baoth...
	Usage of Prony parameters generated in Mcalibration (using DMA experimental data) By Amandeep Singh 2 weeks ago \| Last Post: 2 weeks ago	MCalibration Support Questions
	Hi, I am working for the first time with DMA... 2 weeks ago By Amand...
	Problem with laminate!! By Eli_B 3 weeks ago \| Last Post: 3 weeks ago	PolyUMod Support Questions
	I need to simulate the impact of a steel hemispher... 3 weeks ago By Eli_B
	Fit of initial_modulus vs log(strain_rate) master curve using prony series By Amandeep Singh 2 months ago \| Last Post: 3 weeks ago	MCalibration Support Questions
	Dr. Jorgen, Thanks for your suggestions agai... 3 weeks ago By Amand... I would not trim the curve/points unless you have ... 1 month ago By Jorge... Dr. Jorgen, Thanks for your suggestions! I mis... 2 months ago By Amand... I am not convinced that you did something wrong wi... 2 months ago By Jorge... Hi, I am working on generating a strain rate bas... 2 months ago By Amand...
	DMA/Rheology optimization running slower and slower (1 viewing) By Gorjin 4 weeks ago \| Last Post: 4 weeks ago	MCalibration Support Questions
	Hi, I am trying to do a PRF-model for melted pla... 4 weeks ago By Gorji...
	Questions about fitting to ANSYS Ogden Hyperfoam model By Slaterim 4 weeks ago \| Last Post: 4 weeks ago	Foams
	Compression data fitting (including transverse str... 4 weeks ago By Slate...