Notifications
Clear all

Merged Orphan Mesh and Original Mesh


lalaram
Posts: 7
Topic starter
(@lalaram)
Active Member
Joined: 12 years ago

I created an orphan mesh and I merged it with the original one. I put springs in the orphan mesh. After I merged them the model turned green. I wanted to apply boundary conditions and run a job but I am not able to. Did I skip over a step and do the whole thing again?..which by the way took me a long time. Or is there a way to regenerate it or make it active with the new part instance?

Topic Tags
1 Reply
Jorgen
Posts: 3944
Moderator
(@jorgen)
Member
Joined: 2 years ago

I dont quite understand your question. Are you talking about Abaqus/CAE?

-Jorgen

Topic Tags
1 Reply
Share: