Notifications
Clear all

Hill anisotropy in Abaqus

2 Posts
2 Users
0 Likes
1,018 Views
Posts: 4
Topic starter
(@dheeraj)
New Member
Joined: 12 years ago

Hey friends

I am modelling plasticity with isotropic hardening in abaqus. when I use mises plasticity, I have no problem and everything goes well, but when I switch to hill plasticity by adding the potential option from suboption in material properties edit section, the analysis starts plastcity from start of analysis and I do not have the elastic behavior before plasticity, ie plasticity starts in very low stresses and the material starts to yield at zero stress!!!

I dont know wheather I have missed sth in material properties or ..., I have good results when I delete the potential option

1 Reply
Posts: 3993
(@jorgen)
Member
Joined: 4 years ago

do not post the same question twice :p

1 Reply
Share: