Nitrile Rubber Lip ...
 
Notifications
Clear all

Nitrile Rubber Lip Seal Modelling-MV constant help

1 Posts
1 Users
0 Likes
364 Views
bartek
Posts: 2
Topic starter
(@bartek)
New Member
Joined: 5 years ago

Hello everyone ,

I am new at viscoelastic modelling at ansys so I am studying to model Nitrile rubber and I am using Mooney Rivlin 2 parameters model but I have not posibility to obtain experimental test data in my lab so I researched coefficients in literature then I found C10=1.87 MPa, C01=0.47 MPa. After I enter these values although radial force on the lip was too low (25N), solution did not converged .My question is can I use these litreture values instead of using experimantal data, also should I change hyperelastic model Mooney Rivlin? [TABLE=class: table table-hover table-striped searchResultsTable]
[TR]
[TD=class: tr ts] [/TD]
[TD=class: en tm] [/TD]
[/TR]
[/TABLE]

Topic Tags
Share: