Activity
 
Notifications
Clear all
Jorgen
Jorgen
Group: Moderator
Joined: 2019-09-29
Title: Member Moderator
Hello, No there are no other constraints that you need to ap...

In forum MCalibration Support Questions

2 days ago
PolyUMod and Ansys 2021R2

In forum PolyUMod Support Questions

2 months ago
It sounds like your issue may be caused by element distortio...

In forum Finite Element Modeling

2 months ago
Since that behavior is so unusual, your best bet might be th...

In forum MCalibration Support Questions

2 months ago
I'm not sure how accurate that would be. I recommend using M...

In forum Foams

2 months ago
Yes, absolutely! As long as you provide the correct geometry...

In forum Foams

2 months ago
Yes, that should work fine. Note, however, that the PN model...

In forum MCalibration Support Questions

2 months ago
Here is some experimental data for ABR (Nitrile) rubber. /...

In forum Experimental Data

3 months ago
There are 2 ways to do that. The first is to use an equation...

In forum MCalibration Support Questions

3 months ago
That sounds odd. I would be happy to investigate if you atta...

In forum Finite Element Modeling

3 months ago
It is difficult to say what the problem is without more info...

In forum MCalibration Support Questions

3 months ago
I would not trim the curve/points unless you have experiment...

In forum MCalibration Support Questions

3 months ago
That is very strange indeed. Not sure what is going on. I ...

In forum Computer Software

3 months ago
This is just a test message to see if I can insert a mcal-fi...

In forum Elastomers

3 months ago
Hm. That is odd. I just looked in the Abaqus User's Manuals ...

In forum Computer Software

3 months ago
Page 1 / 262
Share: