Practical Differences Between Linear and Non-Linear Viscoelasticity
Review of some practical differences between linear and non-linear viscoelasticity.
Menu
Search Results
Note that the search results shown below do not include our more than 12,000 forum articles. Repeat your search on the Forum page to find more results!
Category: MCalibration
Strain Amplitude Sweeps in MCalibration
Quick demo of how to setup a strain amplitude sweep in MCalibration.
Instantaneous Calibration of Abaqus Linear Viscoelasticity using DMA Data
Summary of how you can instantaneously calibrate an Abaqus linear viscolastic material model using DMA data using MCalibration version.
Toe-in Compensate Experimental Data
Detailed description of how the toe-in compensation function in MCalibration works.
How to Predict Permanent Set in Rubbers
Discussion about how to test end model the permanent set of rubbers
5 Common Mistakes when using Hyperelasticity
Here’s a summary of 5 common mistakes when using Hyperelasticity in a FE model. I see these errors frequently, so read this article to make sure you don’t make them too.
Plot Viscoplastic Strain in PolyUMod and MCalibration
Description of how to plot the viscoplastic strain magnitude when using PolyUMod or MCalibration.
Adiabatic Heating in MCalibration
Tutorial on how to include adiabatic heating in your material model calibration using MCalibration.
New Features: Version 6.1.0
Summary of the key new features of version 6.1.0 of MCalibration and PolyUMod.