Ansys analysis hangs when run from Matlab

**IceBreaker** · 2012-05-30, 19:31

Were you able to find out what exactly the problem was?

CF · 2012-05-31, 12:24

Originally Posted by IceBreaker

Were you able to find out what exactly the problem was?

Nope. One of those problems that thankfully disappears with an update.

**IceBreaker** · 2012-05-31, 12:52

Strange! Well, whatever gets the boat to float!

By the way, if its not a bother, I was hoping you could provide some instructions dealing with material calibration using MATLAB. Is there a webpage that may have helped? A book? Or do you have a document that you might be willing to upload? I may have to perform material calibration myself. It would be of immense value to me.

Thanks.

CF · 2012-05-31, 14:22

Originally Posted by IceBreaker

Strange! Well, whatever gets the boat to float!

By the way, if its not a bother, I was hoping you could provide some instructions dealing with material calibration using MATLAB. Is there a webpage that may have helped? A book? Or do you have a document that you might be willing to upload? I may have to perform material calibration myself. It would be of immense value to me.

Thanks.

Attached are two files, which provide a very rough skeleton of the optimisation approach I took. Some further details of the bigger picture are here:
http://www.springerlink.com/content/...625818/?MUD=MP

Hope that is of some help.

C