polyprophylene Abaqus

[artemioalanis]

I just started using abaqus and i'm concerned with the behavior of my desing. I'm basically doing a simple Static non linear test on a block of polyprophylene and i have these material characteristics.

Elastic Modulus: 1300 N/mm2
Tensile Strength: 37 N/mm2
Density: 9 e-10 Tons/mm3
Possion: 0.41

Is this enough to simulate a good behavior for polyprophylene ?

Thanks for your help.

[artemioalanis]

I think i go this down my results in stress are below the tensile strength by a factor of 3 and my strain is well under the yield strain

Does this meen than i can assum that the region im working in is linear?

[onicroster98]

have no much idea on simulation but there are many ebooks where you can find the polyprophylene linear and non linear test. i would suggest you to seek guidance on the same..